Before Christmas I promised I’d show you some crafty ways of making use of that mountain of wrapping paper that inevitably amasses after Christmas day. If you’ve recycled your paper already (some papers can’t be recycled, see last months post here: link) this is a good way to use up those annoying bits that are too good to recycle but that clutter up your wrapping stash.

Please forgive my less than perfect photos, my 8 year old digicam has served me well but I have a suspicion it’s on its way out!

notebookcollage.jpg

 

origamicollage.jpg

 

You can easily find origami tutorials online and your library may even stock some books. If your new years resolution was to try a new craft, what better excuse to give it a go? This works best with thicker wrapping papers.

Another craft you may enjoy (and which I find very relaxing) is decoupage. You can buy special materials such as decoupage papers and glue/sealer but really all you need is some thin wrapping paper and PVA glue. It’s so simple you can get stuck in without much preparation. The Range stock extremely reasonable wooden shapes. I’ve used a little wooden birdhouse.

birdhousecollage1.jpg

 

You will need:

  • Your base shape (such as my birdhouse)
  • Scrap wrapping paper
  • PVA glue
  • A paintbrush
  • A container with a little water in

Instructions

  1. Tear your wrapping paper into small pieces
  2. Mix a little bit of water in a pot with a blob of PVA glue (make sure to stir well until fully mixed)
  3. Paint a thin layer of your PVA mix onto one area of your shape and put bits of wrapping paper over it
  4. Paint over with your PVA mix
  5. Keep layering and painting on glue until you’ve finished the entire shape
  6. Put somewhere to dry

Useful Tips

  • Don’t mix your glue with too much water or your paper won’t lay flat
  • Smooth the paper as you go along to get rid of any lumps and bumps (yes, you will get a little messy!)

 

This is great to do with children as it’s simple and your get results quite quickly. The next how-to is also fun to do with slightly older children but again be prepared for gluey fingers!

Paper beads

beadcollage

 

You will need

  • Left over/scrap wrapping paper
  • cocktail sticks or kebab skewers
  • PVA glue

Instructions

  1. Mix a small amount of water with PVA glue
  2. Cut strips of wrapping paper approx 1/2 cm in width (the length you use will depend on how layered/thick your beads will be)
  3. Get one of your skewers/cocktail sticks and loosely wrap your paper once, fixing it with a dab of glue (try to avoid getting too much glue on the wood or you won’t be able to get your bead off later!)
  4. Continue to build up, adding a coating of glue as you go and smoothing out gently with your fingers
  5. Once you reach the end of your paper strip, make sure the outside has a coating of glue and either put your bead stick somewhere to dry or continue using it
  6. Leave until completely dry (the glue will have given your beads a slight gloss and hardened them up) then gently twist to get your bead off the stick.

Tips & Notes:

There are two ways you can make your beads, either tapered at the ends or just even. To get a tapered effect (like the red beads above) your beads will be a bit longer as you need to work from one side to the other. The easiest way is to just keep rolling your paper up, but once you’ve practised a little you can start trying other ways of wrapping.

This works best with brighter, patterned paper and you can use this method with fabric too. Get creative and try wrapping bright threads around your beads!

The most useful tip is to NOT WRAP TOO TIGHTLY around your cocktail stick/skewer as you won’t be able to get your bead off. I made this mistake myself when I started learning to make paper beads but you’ll soon get the hang of learning just the right ‘hold’ on the stick.

Whilst I waited for my wrapping paper beads to dry, I made a bracelet using some paper and fabric beads I’d already wrapped before. For these I used scraps of handmade paper, felt scraps, recycled sari material and even some left over paper I’d been stamping on (rubber stamping that is! Not foot stamping!)

bracelet.jpg